Repair Instructions
Replacing and Installing a Arc Gear on the Platform.
Elite Models that Apply: EL04, EL05, EL05-LE
Step
Description
Step 1.) Unscrew the (6) Phillips-head screws along the
bottom of the red case where it attaches to the chassis
1
of the machine. (2-front, 2-rear, one on each side)
Step 2.) Lift the red case off the chassis and set it aside.
Step 1.) Using a 9/16" crescent wrench, and a 9/16"
wrench, hold onto the bolt which is outside of the
machine underneath the platform, while unscrewing the
nut attached to the other end of the bolt, inside the
machine (below the bottom server wheel).
2
Step 2.) With the Platform detached, position it so that
the 4 rubber feet are touching the ground, and the white
plastic spacer is pointing up.
support@lobsterinc.com
Removing The Case
Removing The Platform
Phone: 800.526.4041
Tools
Picture
Case Screws (Front & Rear)
Phillips Screw
Driver
Case Screws (Side)
Phillips Screw
Driver
Platform with Nut removed.
9/16" Crescent
Wrench
9/16" Wrench
Platform being removed from
Fax: 818.764.6061
Case Removed
Chassis.