Advertisement
8 press <select>key to shift to time countdown setting, press <fast>/<slow>或<up>/<down> key to set time
countdown value；
9 press <START>key to start workout.
During running, speed and incline will be adjusted automatically according your hear rate to make current rate
to meet preset value.
Table 4-6-1 value setting range
Project range
TIME 5~99
AGE 18~70
WEIGHT 35~250
SEX MALE .FEMALE
TARGET HEART RATE 70-190
V.Controller error handing
5.1. Safety key not in right position ：E0
treatment：check safety key，input it and get controller power on。
5.2. Speed signal lost ：E1
treatment：check speed sensor , connect it and get controller power on.
5.3. Overload fault ：E 2
Treatment ：controller power on, clear error.
5.4. Motor abnormality ：E 4
Treatment ：check connection of motor, and the voltage stable or not, after checking restart to clear error.
5.5. Correspondence interrupt ：E5
Treatment ：check correspondence connection .
5.6. Low-voltage protection：E 6
Treatment ：check voltage ,or if power tube breakdown ,if power tube problem ,need to replace a new one.
BELT ADJUSTMENT
You may need to adjust the running belt during the first few weeks of use. All running belts are properly set
at the factory. It may stretch or be off-centre after use. Stretching is normal during the break-in period.
ADJUSTING THE BELT TENSION
If the running belt feels as though it is "slipping" or hesitating when you plant your foot during a run, the
tension on the running belt may have to be increased.
TO INCREASE THE RUNNING BELT TENSION:
A. Place 8MM wrench on the left belt tension bolt. Turn the wrench clockwise 1/4 turn to draw the rear roller
and increase the belt tension.
B. Repeat STEP A for the right belt tension bolt. You must be sure to turn both bolts the same number of
turns, so the rear roller will stay square relative to the frame.
C. Repeat STEP A and STEP B until the slipping is eliminated.
D. Be careful not to tighten the running belt tension too much as you can create excessive pressure on the
front and rear roller bearings. An excessively tightened running belt may damage the roller bearings that
would result in bearing noise from the front and rear rollers.
TO DECREASE THE TENSION ON THE RUNNING BELT, TURN BOTH BOLTS
Advertisement
