Extreme Networks ES8500A User Manual page 11

II.Function
2.1 Manual Mode（P1） ：
Can set time countdown, distance countdown and calorie countdown workout modes to start countdown
running.
Can start running directly.
2.2 Automatic programming mode（P2~P6） ：
Preset program，P2～P6 ,every program with 10 levels.
2.3 heart-rate control program （HRC）
According heart-rate, system adjust speed and incline automatically.
2.4running speed：1-22km/h
2.5incline range：0-20%
III.Engineering mode
3.1 Enter method：
Without safety key, in "E0" state，press <SELECT >key，input safety Key, enter engineering mode. Press
<SELECT >key to shift set value. System start speed adjust and test, before that make sure speed sensor
connected.
3.1.1 engineering 1：
Set wheel diameter value: （for speed adjust and test）
Default value 42，range 33-128
Set minimum speed ：
Default value 10，range: 6-10
Set maximum speed：
Default value 250，range: 100-250
Set incline maximum level=：
Default value 20，range: 10-20
3.1.2 engineering 2：
Set current-limiting：
Default value 12，range 5-30
PS： engineering mode 2 will display pwm-min and pwm-steps value， after speed adjust and test ,the two values
will update. Default value should set by hand ahead
3.2 start speed adjust and test
After set engineering value, press<START>key to start speed and incline adjust and test, need patience here
After adjust and test, system will restart.
IV.Operation
All operation should make sure safety key in right location, or will be E0.
4.1 【power on】
Before power on, connect safety key.
After power on, display will show and then version number.
Then enter standby position, default program P1.
4.2 【start working】
Press <START>key，show 3 -2- 1 time countdown, after 3s，start current program.
4.3 【stop working】
In working position，press <STOP>key，motor and incline pause
Press <START>key to go on working, or long press <STOP>key to reset.
4.4 【set manual program】