Renesas user system interface cable user's manual (36 pages)
Summary of Contents for Renesas Temporary Target Board M38517T-ADS
Page 1
On April 1 , 2010, NEC Electronics Corporation merged with Renesas Technology Corporation, and Renesas Electronics Corporation took over all the business of both companies. Therefore, although the old company name remains in this document, it is a valid Renesas Electronics document. We appreciate your understanding.
Page 2
Renesas Electronics. Renesas Electronics shall not be in any way liable for any damages or losses incurred by you or third parties arising from the use of any Renesas Electronics product for an application categorized as “Specific”...
Page 3
M38517T-ADS User’s Manual Temporary Target Board for M38507ARLSS and M38517RSS Rev.1.00 2003.09...
Page 4
• These materials are intended as a reference to assist our customers in the selection of the Renesas Technology product best suited to the customer's application; they do not convey any license under any intellectual property rights, or any other rights, belonging to Renesas Technology Corporation, Renesas Solutions Corporation or a third party.
1. Things to Check When Unpacking The M38517T-ADS package consists of the following products. When unpacking your package, check to see that all of these components are included. Table 1.1 Package components Temporary target board User's manual * If you find any item missing or faulty, or any suggestion, contact your local distributor. 2.
4. Setting Up This chapter describes how to set up the M38517T-ADS. CAUTION Note on Setting Up: • Always shut OFF power before connecting this product. The power ON state could destroy internal circuits. 4.1 Mounting an Emulator MCU Mount an emulator MCU on the M38517T-ADS. After checking the position of the No. 1 pin of the emulator MCU, mount the emulator MCU referencing Figure 4.1.
4.2 Connecting to the Emulation Pod (1) Insert the connector on the tip of the emulation pod probe to the socket on the emulator MCU. (2) Connect the cables of the M38000TL2-PSW2 as shown in Table 4.1 depending on the emulator MCU you use.
Figure 4.3 Connecting the M38517RSS 4.3 Setting the Switches Set the switches SW1 to SW3 according to your applications. Table 4.3 describes the functions of the switches SW1 to SW3. Table 4.3 Functions of the switches SW1, SW2 and SW3 Name PORT/XCIN Allows you to choose whether to supply the sub-clock...
5. Oscillator Circuit 5.1 Oscillator Circuit Board The M38517T-ADS has a built-in oscillator circuit board on which a 4.0MHz oscillator is mounted. Figure 5.1 shows an external view of the OSC-2 oscillator circuit board (bare board) and where connector pins are located. Figure 5.2 shows the circuitry of the OSC-2 oscillator circuit board (bare board).
6. Reset Circuit Figure 6.1 shows the reset circuit and its waveform. In this product, reset is cleared in about 100 ms from the instant Vcc passes about 2.1 V after having started from 0 V. When Vcc drops down to about 2.1 V, reset turns effective.