Lattice Semiconductor MachXO5-NX Development Kit Quick Start

QuickSTART
This document provides a brief introduction to the MachXO5™-NX Development Kit.
DIP
Switches
(SW1)
User LEDS
(D1~D8)
VS8 (J23)
VIOS (J25)
VS7 (J22)
VS6 (J21)
Check Kit Contents
1
The MachXO5-NX Development Board kit contains the following items:
MachXO5-NX Development Board
„
12 V AC/DC Adapter and International Plug Adapters
„
USB Cable for Programming via PC (USB-A to Mini-B)
„
Quick Start Guide
„
Lattice Radiant software download information
„
Using the MachXO5-NX Development Board
2
The MachXO5-NX Development Board as shipped supports Internal Flash boot-based
configuration. The internal Flash Configuration Memory is pre-loaded with a LED blink-
ing demonstration program.
Installing the software
3
The MachXO5-NX Development Board is pre-programmed with a basic demonstration.
To develop your own solutions, download and use the Lattice Radiant design software
(version 3.1 or later) in www.latticesemi.com/software.
If you only need to re-program the board, you can use the Radiant Programmer Stand-
alone software (version 3.1 or later).
MachXO5™-NX Development Kit
Power Segment
Switch LED Displayer Config USB
(SW6) (D20) Header (J11)
MachXO5-25
Device (U3)
VS4
(J29)
Done LED
(D10)
INIT LED
(D11)
Power LED
(D18)
VS3 (J26)
VS5 (J20)