Replacing The Lamp; Replacing The Charcoal Filter - Zanussi ZFPT16S User Manual

1
2
2. Slightly tilt the front of the filter downwards (2),
then pull.
Repeat the first two steps for all filters.
3. Clean the filters using a sponge with non
abrasive detergents or in a dishwasher.
The dishwasher must be set to a low
temperature and a short cycle. The
grease filter may discolour, it has no
influence on the performance of the
appliance.
4. To mount the filters back follow the first two
steps in reverse order.
Repeat the steps for all filters if applicable.

REPLACING THE CHARCOAL FILTER

WARNING! The charcoal filter is
NON-washable! The filter cannot be
regenerated!
To replace the charcoal filter:
1. Remove the grease filters from the appliance.
Refer to "Cleaning the grease filter" in this chapter.
2. Turn the filter counterclockwise (1) and then
pull (2).
To mount the filters back follow the steps in reverse
order.
4
1
2

REPLACING THE LAMP

WARNING! Risk of burns and electric
shock! Disconnect the appliance from
the electricity before the operation!
Make sure that the light bulb has
cooled down before touching it.
WARNING! Risk of injury! Use
protective gloves to replace the lamp.
Risk of damage to the appliance! Do
not use sharp edged tools!
Replace the burnt light bulb in accordance with the
specifications:
Power (W)
Socket
Voltage (V)
Dimensions (mm)
ILCOS D Code (ac-
cording IEC 61231)
To replace the lamp:
1. The lamp cover has two slots on each side (1).
Use a flat non sharp plastic tool. Gently remove
the lamp cover from the appliance (2).
2. Replace the lamp.
3. Mount the lamp cover.
4
E14
220 - 240
37 x 100 (diameter x
length)
DRBB/
F-4-220-240-
E14-37/100
1
2