Hitachi CPX380W Service Manual page 25

Before mounting the ballast cover
When connecting the CNPWR connector to
the CN101 connector, make sure they are
completely locked.
Keep the CNTH passing through a
hook of the Power PCB Holder as
shown in the diagram below.
CNPWR
Lamp
lead
CNTH
Style the lamp lead as shown in the diagram.
At the time, be careful not to let the lead ride on
the igniter box. (Because if it rides on the box, it
becomes impossible to install the ballast cover)
Check that the black cover of a lamp lead is securely
inserted into the connector.
If even a trivial portion of the white cover is visible inside
in a state where the black cover is not inserted into the
connector as shown in the diagram
on the right, shift the black cover appropriately and
insert it into the connector.
(Ascertain double coating to ensure safety standard)
(Correction work is accompanied by difficulty
in later process)
After mounting the ballast cover
Igniter box
Make sure - as shown in the diagram - that
the CNBAR is passed through a notch on
the ballast cover.
White cover
on lamp lead
Shift the black
cover of the
lamp lead.
Black cover
on lamp lead
CNBAR