Replacing The Thread Catcher Loop Tape - Janome MB-7e Service Manual And Parts List

Replacing the Thread Catcher Loop Tape

Setscrew A
Setscrew B
Upper thread catcher holder
2 mm
Spacers (S)
Setscrew B
Lower thread catcher holder
Loop tape
1. Remove the head set right cover (unit) (see page 5).
2. Remove the thread catcher panel and lower thread
guide plate (see pages 8).
3. Remove the setscrews A (4 pcs.) and remove the
thread catcher holder unit.
4. Remove the setscrews B (2 pcs.) and remove the
spacers (2 pcs.) (S) and the lower thread catcher
holder.
5. Peel the loop tape off. Stick a new loop tape on the
bottom side of the thread catcher holder, aligning with
the front edge of the holder. Leave a 2 mm space from
the threaded hole at each side.
6. Attach the spacers (S) (2 pcs.) and lower thread catcher
holder with the setscrews B (2 pcs.).
7. Attach the parts removed in steps 1 and 2.
2 mm
39