Advertisement
photovoltaic module is connected, can
result in loss of life.
4.1 General safety measures
•
Before installation, please contact the relevant
local authority to determine the installation
permit and installation inspection requirements
that
meet
the
installation process should comply with the
safety rules applicable to all components in the
system, including cables, terminals, charging
monitors, batteries, inverters, etc.
•
If you install or operate photovoltaic modules on
a rainy day or in the morning with dew, you
need to take appropriate protective measures to
prevent water vapor from penetrating into the
connectors.
•
Unauthorized personnel are prohibited from
approaching the installation area or photovoltaic
module storage area.
•
It is forbidden to install or use damaged
photovoltaic modules.
•
It is forbidden to repair photovoltaic modules by
yourself, including but not limited to replacing
any components of photovoltaic modules
(diodes, junction boxes, connectors, etc.).
•
It is forbidden to plug in connectors of different
types and models.
•
It is forbidden for photovoltaic modules to be
used or exposed to the following substances in
an
environment
substances:
grease
compounds
(such
aromatics,
phenols,
substances, mineral oil, alkanes (Such as
gasoline,
cleaning
resurrection agents), alcohol, certain drugs
(white flower oil, active oil, bone-setting water,
thinner), adhesive sheets that can generate
oxime gas and potting glue (only for connectors)
(Such as KE200, CX-200/chemlok, etc.), TBP
(plasticizer), detergent, etc., to avoid chemical
8 Star Energy Pty Ltd | Level 35, 477 Collins Street, Melbourne VIC 3000 | https://www.energizersolar.com
4
8 Star Energy ESS Ltd | The Black Church, St Mary's Place, Dublin DO7 P4AX, Ireland
local
requirements.
containing
the
following
or
organic
ester
as
DOP,
plasticizers),
ketones,
halogenated
lubricants,
electronic
damage
performance of photovoltaic modules.
•
It is forbidden to install photovoltaic modules in
windy weather due to safety issues.
•
It is forbidden to focus sunlight on photovoltaic
modules via external means.
The
•
It is forbidden to use photovoltaic modules in
relevant places such as movable platforms
(except for tracking brackets).
•
It is forbidden to disassemble and move any
part of the photovoltaic module; if the connector
of the photovoltaic module is wet, do not
perform any actions to avoid the risk of electric
shock.
•
Do not connect or disconnect the photovoltaic
module when there is current or external current
from the photovoltaic module.
•
The cover of the junction box should always be
kept closed.
•
Avoid partial shading of photovoltaic modules
for a long time. Otherwise, the temperature of
the shaded solar cells will rise (hot spot effect),
and in severe cases, the photovoltaic modules
may be burned, or even a fire may occur.
•
For photovoltaic modules used in deserts or
windy and sandy areas, it is recommended to
use connector dust caps before installation, or
take other measures to prevent sand and dust
from entering the connectors, otherwise it may
cause insertion problems or electrical safety
hazards.
4.2 Operational safety measures
•
During
transportation
packaging damage due to falls or mis-treatment;
ensure that the packaging boxes are ventilated,
protected from the rain and dry; after arriving at
the installation site, carefully open the outer
packaging to prevent scratches and bumps on
the photovoltaic modules due to improper
unpacking.
and
affect
the
electrical
and
storage,
When
stacking
safety
avoid
photovoltaic
Advertisement
