Coolant radiator and oil cooler - check
Walk-around inspection of coolant radiator (1) and oil cooler (2)
for tightness and dirt.
If there is any dirt etc. on the radiators:
Clean coolant radiator (1) and hydraulic oil radiators (2) from
the engine with a water jet or a compressed air gun. Do not use
high-pressure cleaners.
Remove the screw (1) and pull on the handle (2) of the oil cool-
er (3) to fold it away from the coolant radiator.
Particular care must be devoted to the space between the radi-
ators because foliage often collects at this point.
After cleaning, check coolant radiator and hydraulic oil radiator
for damage.
Finally, fold the oil cooler (3) back and tighten the screw (1).
V-belt - check
The engine must be switched off and the key removed!
STOP
Do not attempt to grasp rotating or moving parts.
Press in the V-belt (1) at position "A". The V-belt must give way
for approx. 7-9 mm (pressure: 6-7 kg). Adjust the V-belts if nec-
essary (page 156).
Check condition of the V-belt, it must not have any cracks or
other damage. Replace the V-belts if necessary.
68
Operation
1
A
RG268-8135-6
01/2019