Table of Contents
Advertisement
Quick Links
ISD8001: Industrial ScentDirect
Diffusion System
Wall Mount Instructions
REQUIRED TOOLS
1. PENCIL
2. TAPE MEASURE
3. #2 and #3 PHILLIPS HEAD SCREW DRIVER
4. SMALL LEVEL
5. Electric drill
6. Drill bits ( 3/16", 5mm and ½", 13mm )
7. Masonry Drill bit (5/16" , 8mm )
8. Electronic Studfinder
The articulated Wall Mount includes its own hardware kit, and is supplied with 3 additional
snaptoggle anchors and screws for use in commercial metal framed walls.
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for ScentAir ISD8001
Summary of Contents for ScentAir ISD8001
- Page 1 ISD8001: Industrial ScentDirect Diffusion System Wall Mount Instructions REQUIRED TOOLS 1. PENCIL 2. TAPE MEASURE 3. #2 and #3 PHILLIPS HEAD SCREW DRIVER 4. SMALL LEVEL 5. Electric drill 6. Drill bits ( 3/16”, 5mm and ½”, 13mm ) 7. Masonry Drill bit (5/16” , 8mm ) 8.
- Page 2 The wall mount bracket is installed on the wall first and then the ISD8001 is hung and secured. The mount is supplied with 6mm dia coarse thread screws that can be used in wood framing or (with plastic anchors ) concrete or masonry walls. Please refer to the instructions provided with the Mount itself ( pages 1-5 ) for attaching the mount to these materials.
- Page 3 2 of the M6-1x20mm machine screws on the upper two mounting holes on the back of the ISD8001. Now the ISD8001 can be lifted into place onto the mounting plate of the wall mount with the screws in the upper slots of the mount plate shown here.
- Page 4 ISD8001: Industrial ScentDirect Diffusion System Wall Mount Instructions OPERATING INSTRUCTIONS Bottle - Installation and Replacement Open machine door by turning lock. Disconnect quick connect “output” tube by pressing the lever and pulling up on the tube. Leave tube in machine.
- Page 5 ISD8001: Industrial ScentDirect Diffusion System Wall Mount Instructions The ON time is the time of day that the system will begin operating. Set the ON time by pressing the PROGRAM SET button until “Event 1 ON” begins to flash. Use the + or –...
- Page 6 Units should start immediately and run in the ON restored after a timed mode until the designated OFF time. event has started -OR- MASTER POWER is switched on after a timed event has started For further assistance please contact Technical Services at: Phone # 704-504-2320 E-mail: techservices@scentair.com...
- Page 7 ISD8001: Industrial ScentDirect Diffusion System Wall Mount Instructions ISD-8001 MAINTENANCE GUIDE Unit Cleaning Unit should be cleaned with a soft damp cloth. Isopropyl or Denatured Alcohol may be used to clean any oil spill or contaminants from the housing (inside and outside).
Need help?
Do you have a question about the ISD8001 and is the answer not in the manual?
Questions and answers