Troubleshooting - Hisense HDFY80H User Manual

24
2. Turn the locking knob of the
base filter cover to unlock
position.
3. Remove the base filter cover
and take out the base filter.
After several times of use, clean
the dust on the base filter with a
wet cloth or flowing water. After
using for a period of time, if there
is dust on the heat exchanger,
please remove the dust with
tools. Do not touch the heat
exchanger directly with your
hands to avoid injury.
4. Install the cleaned filter and
filter cover back to the original
positions, lock the knob and
close the heat exchanger door
cover.

7. Troubleshooting

When the machine fails to operate normally, it may not be a fault. Please refer to the
following methods for troubleshooting. If the fault still exists after self handling
according to the recommended method, please unplug the power supply and contact
us for after-sales service.
All consequences caused by the maintenance by the user himself or by hiring non-
professional after-sales personnel will be borne by the user.
Fault phenomenon
Check the power connection;
The dryer cannot be
Confirm the "Start Pause" key is pressed down;
started
Confirm the door is closed properly;
House fuse is blown, circuit breaker has tripped,
or power outage has occurred.
The dryer cannot be
Check whether the program setting is correct;
started and displays
Confirm there are clothes in the drum;
"End"
Check whether the program setting is correct;
Confirm whether there are too many clothes
wrapping into clusters;
Excessive drying time
Check whether the filter screen is cleaned;
There will be air supply for cooling after drying in
some programs;
Confirm that the clothes have been dehydrated;
Check whether the program setting is correct;
Poor drying effect
Confirm that there are too many clothes;
Load is not properly sorted. Whether clothes that
are not easy to dry are mixed with clothes that are
easy to dry;
Large load of heavy fabrics.
Check whether the filter screen is cleaned;
The remaining time of
The remaining time varies with clothing type, load,
the display stops or
dehydration and ambient temperature, which is a
jumps
normal phenomenon;
Clothes have dried too long. Try a shorter drying time.
Clothes have been left in the appliance for too long
Clothes are wrinkled.
after cycle ends.
Recommended handling method
25