Advertisement
Quick Links
HNS010RL
OWNER'S MANUAL
Scan our QR code
with your phone to go
directly to our website
for technical information
1. FEATURES
• Boosts the current capacity of a circuit controlled by an external switching device, such as CABAC 3-wire
S-Click products HNS440TM, HNS450TM and HNS460SW to 10A.
• Compatible with a wide range of popular switch wall plates and accessories.
• Cable tie mounting feature, for alternative in-wall installation.
2. OPERATING CONDITIONS
• Operating Voltage:
• Operating Temperature:
• Compliance Standard:
• Maximum Current Capacity
3. LOAD COMPATIBILITY
Incandescent
240V Halogen
Fluorescent Tube with electronic ballast
Fluorescent Tube with iron core ballast
Compact Fluorescent
Electronic Transformer
LED
Wirewound Transformer
Fan Motors
Heating Elements
NOTE: Operation at temperature, voltage or load outside of the above specification may cause permanent
damage to the unit.
Note: This manual was correct at the time of manufacture. For the latest version of the manual and any technical or
safety updates refer to the website:- cabac.com.au, cabac.co.nz or scan the QR code with a mobile phone.
B
™
R
3
230 – 240V a.c. 50Hz
0 to +50 °C
CISPR15, AS/NZS 3100
10A, 6AX
ü
ü
ü
ü
ü
ü
ü
ü
ü
ü
3-WIRE
SUITABLE FOR FANS,
MOTORS OR IRON
CORE BALLASTS
Advertisement
Related Manuals for CABAC HNS010RL
Summary of Contents for CABAC HNS010RL
- Page 1 CORE BALLASTS 1. FEATURES • Boosts the current capacity of a circuit controlled by an external switching device, such as CABAC 3-wire S-Click products HNS440TM, HNS450TM and HNS460SW to 10A. • Compatible with a wide range of popular switch wall plates and accessories.
- Page 2 Either one of the control inputs must be connected to Neutral output and the other connected to the Load output of the HNS440TM, HNS450TM or HNS460SW, see diagram below. The wiring diagrams below show how to configure the HNS010RL for Normally Open (load normally OFF) and Normally Closed (load normally ON) applications.
- Page 3 5.1 FRONT COVER • A front cover must be fitted at all times to the HNS010RL to ensure safe installation. • Choose the appropriate front cover for the wall plate (front covers to fit suitable Clipsal and HPM wall plates are enclosed).
- Page 4 • Using the cable tie feature of the HNS010RL, the unit can be mounted in-wall if required. • Figure 5 shows an example of how the HNS010RL may be mounted in-wall by using the cable tie feature of both the HNS010RL and the Cabac 3-Wire S-Click range products (e.g. HNS440TM, HNS450TM or HNS460SW).