Related Manuals for Kendall Howard ESDW-9630-1000
Summary of Contents for Kendall Howard ESDW-9630-1000
- Page 1 Save This Manual for Future Reference ® 96” ESD WORKBENCH Owner’s Manual Part Number: ESDW-9630-1000 For Your Safety Read and understand the entire manual before use Page | 1...
-
Page 2: Table Of Contents
The information contained in this document is subject to change without notice or obligation. Kendall Howard LLC assumes no responsibility for the accuracy, completeness or reliability of the information contained in this document. -
Page 3: Dimensional Drawing
Save This Manual for Future Reference Dimensional Drawing Specifications Overall Dimensions 96” Wide x 30” Deep x 30” Tall (at lowest setting) Worksurface Dimensions 30” Deep x 96” Long Weight 185 lbs. (407 kg) Workbench Support Color Gloss Black Powder Coat Worksurface Color Cloudy Gray Tools Needed... -
Page 4: Component Identification
Save This Manual for Future Reference Component Identification What’s included? Work Surface 96” x 30” (1) Leg Assembly (2) Part Number: A-1071 Part Number: A-1075 Cross Bar (2) Gusset (2) Part Number: A-1079 Part Number: A-1080 Pan Head Screw (44) ESD Grounding Boot (1) Part Number: HW-PHS-006 Part Number: A-1084... -
Page 5: Installation
Save This Manual for Future Reference Installation Step 1: Cut and remove the two plastic banding and any shrink wrap material, remove top from crate packaging & remove components. Step 2: Place the Work Surface on its top on a clean and sturdy working area. Locate the two leg assemblies and 16 Pan Head Screws. -
Page 6: Installation Continued
Save This Manual for Future Reference Installation Continued Step 4: Locate the Cross Bars and 20 Pan Head Screws. Install 10 screws into each cross bar as shown below. Step 5: Determine how the Workbench will be grounded. If using the ESD Grounding Boot, proceed to step 6. -
Page 7: Esd Electrical Circuit
Save This Manual for Future Reference ESD Electrical Circuit Work Surface A wire connects the conductive aluminum boot to a common ground located in worksurface. A wire is connected from the common ground to an external Earth ground wire. A wire is connected from the common ground to the wrist strap ground point. -
Page 8: Troubleshooting
Save This Manual for Future Reference Troubleshooting ESD non-compliant on work surface & common grounds • Verify that the flooring has a RTT value of 10⁵<10⁹ Ohms resistance. • Verify that the ESD surface has a RTT value of 10⁵<10⁹ Ohms resistance. If it does not, clean and repeat test. -
Page 9: Warranty
MISCELLANEOUS: NO SALESPERSON, EMPLOYEE OR AGENT OF KENDALL HOWARD IS AUTHORIZED TO ADD TO OR VARY THE TERMS OF THIS WARRANTY. Warranty terms may be modified, if at all, only in writing signed by a Kendall Howard officer. This Warranty is effective as of the date of Kendall Howard receipt of full payment and supersedes all previous warranties Kendall Howard reserves the right to supplement or change the terms of this Warranty in any subsequent warranty offering to User or others.