Mark Levinson 5909 Faq

Mark Levinson № 5909 FAQ

HOW DO I PAIR MY HEADPHONES TO MY DEVICE?

Hold the Power ON/OFF button down for >5 seconds. Status light will pulse White when headphones are in pairing
mode. Release. Access Bluetooth settings on your source device. Locate "№ 5909" and connect. A solid white light
indicates you are connected.

HOW DO I PAIR TO TWO OR MORE DEVICES?

1. Enter pairing mode and connect to device 1.
2. Enter pairing mode again and device 1 will disconnect.
3. Connect to device 2 and turn headphone off.
4. Turn headphones on and headphones will automatically connect to device 1 and 2 simultaneously.
5. Pause one device and play from the other to swap headphones connection.
NOTE: Maximum number of devices that can be connected at any given time - 2 source devices.

HOW DO I REMOVE/CHANGE EAR PADS?

To remove ear pads: gently pull the earpads from the top. The snaps will release.
To re-attach ear pads, hook the 2 catches into the slots at the bottom of the earcup. Gently push the earpad
against the earcup, ensuring all the snaps are secured.

WHAT IS THE BATTERY LIFE OF MY HEADPHONES?

34 Hours playtime with full charge / 30 Hours playtime while using ANC.
NOTE: With only 15 minutes of charge time, headphone will gain 6 hours of playback time.

HOW DO I CLEAN AND STORE MY HEADPHONES?

Clean ear pads and headphones with soft, slightly damp cloth. Do not soak, submerge or allow moisture to enter
near the drivers or cable jacks. Replacement ear pads and cables can be purchased through customer support at
www.marklevinson.com
Polishing cloth can be used to wipe down after use / remove finger prints, etc. . .
When not in use, keep your headphones in the provided hard travel case to protect them from dirt and other
substances.

HOW IS ACTIVE NOISE-CANCELLATION DIFFERENT FROM SOUND ISOLATION?

Active Noise-Cancellation is an active, electronic method of reducing unwanted ambient sound that adds
processed sound to your audio to reduce the perception of ambient noise. Sound isolation is a passive, physical
method of reducing external noise that uses optimized materials and designs to reduce the ambient noise that
enters through your headphones.
HOW DO I TURN THE ACTIVE NOISE-CANCELLING / AMBIENT AWARE modes ON?
Your headphones arrive in ANC OFF mode. To switch between modes, press the red ANC button on the left ear
cup, this will cycle between OFF / ANC / AWARENESS. Via the app, you can select the default ANC of HIGH,
ADAPTIVE or LOW and the default AWARENESS level of VOICEPASS or AMBIENT.
© Harman International Mark Levinson № 5909 FAQ rev02022022