First Use And Installation; Operation - Hisense RB296F4AW1 User's Operation Manual

First use and installation

Cleaning before use
Before using the appliance for the first
time, wash the interior and all internal
accessories with lukewarm water and
some neutral soap in order to remove the
typical smell of a brand new product, then
dry thoroughly.
Important! Do not use detergents or
abrasive powders, as these will damage
the finish.
Installation Positioning
Warning! Before installing, read the
instructions carefully for your safety
and the correct operation of the appliance.
Position the appliance away from sources
of heat such as stoves, radiators, direct
sunlight, etc.
Maximum performance and safety are
guaranteed by maintaining the correct
indoor temperature for the class of unit
concerned, as specified on the rating
plate.
The appliance performs well
climate range below
not work properly if it is left for a longer
period at a temperature above or below
that indicated .
Model Clamite class
RB296F4AW1
Important! It is necessary to have good
ventilation around the refrigerator to allow
for the dissipation of heat, high efficiency
and low power consumption.
reason, a sufficiently cleared
be available around the
advisable for there to be 75mm separating
the back of the refrigerator
least 100mm of space on its two
height of over 100mm from its top and a
clear space in front to allow the doors to
open 135°.

Operation

Accessories
1)
Movable shelves/trays
Various glass, plastic storage shelves or
wire trays are included with your appliance-
different models have different combinations
and different models have different
within the
. The appliance may
N、ST、T
For this
space should
refrigerator . It is
to the wall at
sides, a
features.
Hisense Refrigerator
Climate class Ambient temperature
SN
N
ST
T
Appliances must not be exposed to rain.
Sufficient air must be allowed to circulate
in the lower rear section of the appliance,
as poor air circulation can affect perfor-
mance. Built-in appliances should be
positioned away from heat sources such
as heaters and direct sunlight.
Leveling
The appliance should be level in order to
eliminate vibration. To make the appliance
level, it should be upright and both
adjusters should be
the floor. You can also adjust the level by
unscrewing the appropriate level
in the front (use your fingers or a suitable
spanner).
Electrical connection
Caution! Any electrical work required to
install this appliance should be carried out by
a qualified or authorized
Warning!
This appliance must be grounded.
The manufacturer declines any liability should
these safety measures not be observed.
The walls of the refrigerator are equipped
with a series of runners so that the shelves
can be positioned as desired.
8
+10°C to +32°C
+16°C to +32°C
+16°C to +38°C
+16°C to +43°C
in stable contact with
adjustment
personnel.