Cable Specifications; Installation; Net Man Plus Jumper Settings - Riello NetMan User Manual

C S
ABLE PECIFICATIONS
In case it is necessary a cable longer than 5 meters, it is possible to build one following the
schematic in Picture 6 and Picture 7.
Please note that the total cable length must be less or equal than 30 meters and the
Number of devices must be less or equal than 6 (where this device counts 2).
The cable used must be shielded and only one end of the shield should be tied to
protection earth (PE).
Picture 6 netman to sensor interface
Picture 7 sensor to sensor cable
N M
ET AN PLUS JUMPER SETTINGS
In order to use the environmental sensors, please configure the JP6 and JP10 jumpers as
shown below. See also the NetMan plus manual for configuring the other jumpers.
6
ENGLISH

INSTALLATION