HTRC P120 Instruction Manual

12V10A& 24V/5A
7 - Stage Automatic Smart Battery Charger
For Lithium, Lead-Acid, LiFePO4...
( AGM, GEL, SLA , WET , DEEP CYCLE... BATTERIES)

IMPORTANT SAFETY INSTRUCTIONS

Please read this manual and follow the instructions carefully before using.

MAIN FEATURES:

High efficiency (>85%).
Lithium, Lead-Acid, LiFePO4 battery type can selectable
The 7-stage microprocessor controlled charging process
provides the best possible application and enables efficient battery charging.
Charging voltage adapts to temperature, that can prevent over- or under- charging of battery.
Capable of recharging severely discharged or heavily sulfated battery.
Reverse polarity protection, short circuit protection, over-charge protections, parks free contact.
LCD display: voltage, current, temperature etc.
Ease of use. Clear charging status display.
Full microprocessor controlled.
Do not over-charge your battery even it is kept connecting in any mode.
WARNING：
The charger is designed for 12V and 24V Lithium, Lead-Acid, LiFePO4 batteries
with capacity from 6AH - 120AH(12V), 6AH - 60Ah(24V).
Check battery manufacturer specifications before using.
Explosive gases may emitting from battery during charging. Provide
ventilation to prevent flames and sparks.
Do not expose charger to the sun, or under high temperature environment.
Battery acid is corrosive. Rinse immediately with water if acid comes into contact with skin or eyes.
Do not charge a frozen or damaged battery.
Do not charge non-rechargeable batteries.
Do not place the charger on the battery while charging.
Be extra cautious to reduce risk of dropping a metal tool onto battery.
It might spark or short-circuit battery or other electrical part that may cause explosion.
When working with a lead-acid battery, remove personal metal items
such as rings, bracelets, necklaces, watch...
Do not smoke or allow a spark or flame while charging.
In order to reduce risk of electric shock, unplug charger from AC
outlet before doing any maintenance or cleaning.
Not for use by children or by anyone who is unable to follow instructions of this
manual, unless they are supervised by an adult to ensure the proper use of charger.

LCD DISPLAY:

Charger Inside Temperature
Test Mode
An automatic battery test is conducted
Battery voltage is too low or
immediately after the absorption stage, it
battery can't savethe power
monitors the voltage for 10 minutes to
determine if the battery is full or not
Summer Mode
Winter Mode
When the temperature is above
When the temperature is below
+28'C,Reduce the charge voltage
+10'C, Raise the charge voltage
Only for Car mode
Only for Car mode
Battery Capacity
V
V
Charge Current
Charge Voltage
&
Repair Mode Standby
Low Voltage
End of Repair Function
12V 24V
12V/24V Battery
Wrong polarity, please change the connection
of the clamps
Defect battery, please let the battery be
checked by a mechanic and if necessary
change the battery
Bad connection, please check the connection
between the charger and the battery
Battery Full