Table of Contents
Advertisement
INSTALLATION
WALL MOUNTED INSTALLATION
Due to various building materials used for different walls, it is highly recommended you consult your local
1
builder before you install this appliance on the wall.
- Select a location that is not prone to moisture and is located at least 36" (914mm) away from combustible
materials such as drapes, furniture, bedding, paper, trash, etc.
- Use 2 persons to hold the appliance against the wall and determine the final location.
- Place unit face down on a soft, non abrasive surface. Remove the wall bracket (Figure A) from the back of
the unit (Figure B) by removing the screws (Figure C).
NOTE: It is strongly recommended that the metal mounting bracket 4 be screwed into wall studs where
possible. If wall studs cannot be used, ensure that the plastic anchors (included) or the local builder
recommended hardware is used to install the bracket on the wall and the bracket is adequately secured.
- Using the mount bracket as a template, mark out the location holes and then mount the bracket(s) on
to the wall using the wall anchors and screws included or using local builder recommended hardware
for the type of wall to safely secure and hold the weight of the fireplace.
This bracket MUST have the hooks facing upward and level.
A
C
B
3
3
1
3
1
Fasten the metal bracket 4 at the bottom back of fireplace with screws (included), (Figure D).
2
After wall mounting bracket 3 is installed on the wall, 2 person lift appliance and hang on bracket by
inserting two hooks into the two slots on the back of unit (Figures E & F).
Mark the holes for bottom metal bracket 4 on the wall. 2 person carefully dismount the appliance from
the two hooks and safely store again in soft non abrasive location.
Drill and insert 2 pcs anchor in wall for Mounting Bracket 3 hole.
Repeat 2 person lift appliance and hang on bracket for final installation.
Secure bottom mount bracket to wall with screws (included) or recommended by local builder.
Check the appliance for stability ensuring the wall bracket will not pull free from the wall (Figure A).
D
E
F
1
3
1
3
3
4
4
Page 9 of 15
Advertisement
Table of Contents
