Advertisement
Quick Links
INSTALLATION
The power supply must be made on the "Power" input directly at 230VAC.
It uses a stabilized linear power supply or battery.
NOTE :
To comply with the CE standard, install a fuse and switch
REMOTE CONTROL
RECEIVER RF 2 RELAY
OUTPUTS 230V AC
Technical characteristics
Power supply : 230V AC
Maximum consumption : 2.4VA
Relays of a switched circuit : 250V AC – 3 A maximum per relay
Reset input : by contact closure
Antenna : INCLUDED
Working frequency : 433.92Mhz
Relay activation indicator : 5 mm led.
Relay operating mode : Configurable in monostable, bistable, timed 0.1
to 132 sec.
Response time (Transmitter command delay, relay response) 0.2 sec.
Compatibility : Group 3 RF Emitters, TL-300 / TL-301
Weight : 420 grams.
Measurements : 98.75 x 72 x 30 mm.
Working temperature : - 10ºC to + 45ºC
Regulations : Electromagnetic compatibility 89/336/CEE and its
modifications 23/31/CEE and 93/68/CEE, with the ETS 300-200 regulation
Insulation : IP55
www.cebek.com
-
TL-602
Power connection
Fuse
24V input
sat@fadisel.com
switch
Advertisement
Summary of Contents for CEBEK TL-602
- Page 1 REMOTE CONTROL RECEIVER RF 2 RELAY OUTPUTS 230V AC TL-602 Technical characteristics Power supply : 230V AC Maximum consumption : 2.4VA Relays of a switched circuit : 250V AC – 3 A maximum per relay Reset input : by contact closure Antenna : INCLUDED Working frequency : 433.92Mhz...
- Page 2 Install receiver antenna before programming Pairing with sending unit. Each receiver admits up to a maximum of 5 Cebek transmitters from group 3 R.F., which pair it exclusively with them, avoiding remote activation from any other external transmitter. From the factory, the receiver is supplied blank, without associated codes, so it must be programmed so that the specific transmitter can interact.
- Page 3 TL-602 RESET ACTIVATION When activating “RST1” or “RST2”, the corresponding relay will automatically change to the off state, regardless of the order it was previously executing. The length of the cable used for each Reset input should be as short as possible.
- Page 4 If it is used for educational use, its use and assembly under the supervision of teaching staff is recommended. Cebek products have a 3-year guarantee from the date of purchase. Incorrect assembly or handling is excluded.