Bissell CLEANVIEW COMPACT 3508 Series Manual page 11

Cleaning the Brush Roll
WARNING
To reduce the risk of electric shock, turn power switch OFF and disconnect plug from electrical outlet
before performing maintenance or troubleshooting checks.
1
Place vacuum upside down with brush
roll facing upwards. Remove 5 screws
with a Phillips-head screwdriver.
3
Check air passageway for obstructions.
5
When finished cleaning, align brush
roll with belt turning by hand several
times in the direction of the motor to
align the belt on the floor brush.
NOTE: If an object becomes lodged in foot and brush shuts off, turn vacuum
OFF and unplug from electrical outlet.
2
Lift off brush cover and grasp floor
brush at both ends to lift out. Clean
debris from brush roll, motor pulley
and drive belt. If brush roll is worn,
replace as needed.
4
6
Replace the brush cover and 5 screws.
Separate the
hose from the
hose wand base
to look through
hose for clogs.
Remove debris
from this area.
BISSELL.com 11