Current E-WAND Setup Manual page 4

4. Pair and Add Devices
4
In the app under devices, hit the + sign [Fig. A5].
On any E-Wand you wish to pair to the bridge (you can
Figure A7; Hit the + to add a device
add more than one device at a time), press and release
the programming button 3 times (without hearing a
beep) [Fig. 7.8]. The E-Wand will start beeping to indicate
it is searching for a network.
The E-Wand will play a confirmation beep (Ode to Joy)
when it has discovered the network or a failure beep
(Beethoven's 5th) if it did not find a network.
Figure A8; Press and release the
programming button quickly three times
You will see the device pop up in the menu on your Smart
Phone screen. Select the appropriate device, using the
"identify" button if needed [Fig. A7].
Once the device has been identified, hit "register", then
name the device.
If you would like to add any additional devices, repeat
step 4.
E-Wand
Figure A9; Device will show up, hit
Register
Once your devices have been added, use the app to set up
groups, scenes, and schedules as desired.