Wieland Provides Operating Instructions Manual page 26

EN
5. Handling and transportation
26
HANDLING AND TRANSPORTATION
PROVIDES oil separator/tank are internally washed inside with nitrogen so as to guarantee their perfect
conservation also in corrosive environments. In case of sea freight the units are individually wrapped and
the transport is streamlined as its best by using frames that have been devised to fill 20 or 40 foot containers
without leaving empty spaces.
On request it is possible to supply units in wooden cases in compliance with the enforced norms of the
delivering country. The units may be pre charged with nitrogen; make sure to empty from pressure all circuits
before opening.
LIFTING AND TRANSPORTATION MUST ALWAYS BE DONE ONLY BY EXPERT PERSONNEL
Verify on the catalogue the dimensions and weight supplied by manufacturer before handling, in order to
choose a suitable system of lifting.
Steel chain or synthetic fibre slings, resistant to the load to move, can be used.
Some models are supplied with appropriate points of anchorage in order to make the lift easier.
Handle with care and avoid collisions which could compromise the integrity of the unit.
Before handling, always be sure the paths inside the building are suitable to the dimensions of the pressure
equipment.
ATTENTION: DO NOT MOVE THE UNIT WHEN IT IS UNDER PRESSURE