Panasonic FZ-G2 Series Operating Instructions Manual page 16

First-time Operation
NOTE
l To set the password, proceed as follows.
A
Click (Start) -
Click (Start) - [Settings] - [Accounts] - [Sign-in options].
B Click [Password] - [Add].
To display the password input screen every time the computer is resumed from the modern standby or hibernation, perform the following setting.
A Click (Start) - (Settings) - [Accounts] - [Sign-in options].
B Select [Every Time] under "Require sign-in".
A Click
(Start) - [Settings] - [Accounts] - [Sign-in options].
B Select [Every Time] in "If you've been away, when should Windows require you to sign in again?".
l Set the key entry mode to English ("ENG") and enter characters.
The keyboard layout can be added or changed in the following steps.
(Settings) - [Time & Language] - [Language].
A Click (Start) -
B Click a language and click [Options].
C Click [Add a keyboard] and choose a keyboard from the list.
(Start) - [Settings] - [Time & language] - [Language & region].
A Click
B Click - [Language options] in the language.
C Click [Add a keyboard] in "Installed keyboards" and choose a keyboard from the list.
l Remember your password. If you forget the password, you cannot use Windows. Creating a password reset disk beforehand is recommended.
l PC Information Viewer
This computer periodically records the management information of the flash memory, etc. The maximum data volume for each record is 1024 bytes.
This information is only used for estimating the cause in the case when the flash memory goes down by any possibility. They are never sent to outside via
network nor used for any other purpose except for the purpose described the above.
To disable the function, add the check mark for [Disable the automatic save function for management information history] in [Hard Disk Status] of PC Infor-
mation Viewer, and click [OK].
Then follow the on-screen instructions.
(è Operating Instructions - Reference Manual "Troubleshooting" "Troubleshooting" "Checking the Computer's Usage Status")
16
6 Restart the computer
A Click (Start).
B Click (Power) - [Restart].
A Click
(Start).
B Click
(Power) - [Restart].
l A portion of the Panasonic PC Settings Utility functions will be enabled after the computer restarts.
NOTE
l When the "Emergency notification setting" screen appears, read the on-screen messages carefully. Follow
the on-screen instructions. You can set the "Emergency notification setting" after the setup of Windows is
complete.
7 Update the on-screen manual
A Connect to the internet. Sign in to Windows as an administrator.
For further information, refer to
B Update the on-screen manual.
Click
Click
Follow the on-screen instructions.
8 Create a recovery disc
A recovery disc allows you to install OS and restore its factory default condition, in case, the recovery
partition of the flash memory is damaged.
Refer to è
Operating Instructions - Reference Manual "Important Operation/Settings" "Create a
Recovery Disc" about creating the disc.
(Settings) - [Accounts] - [Sign-in options].
Connect to a network.
(Start) - [Panasonic PC Manual Selector].
(Start) - [All apps] - [Panasonic PC Manual Selector].