Panasonic FZ-G2 Series Operating Instructions Manual page 14

First-time Operation
2
1
B
2
2
3
C
<For tablet>
C
2
3
4
3
3
2
D
4
14
2 Connect your computer to a power outlet
A Connect the power cord and AC adaptor.
Hold the plug (B) of the power cord, and securely insert it straight to the end.
B <Only for model with keyboard base> Slide the cover to the arrow direction and then open the cover.
<For tablet> Slide the cover.
C Connect the AC adaptor to the DC-IN jack (C) of the computer.
D Connect your computer to a power outlet.
The shape of AC Plug and AC Outlet depend on the country.
The battery charging starts automatically.
IMPORTANT
l Do not disconnect the AC adaptor until the first-time operation procedure is completed.
l When using the computer for the first time, do not connect any peripheral device (including wired LAN cable)
except the battery pack and AC adaptor.
l Handling the AC adaptor
Problems such as sudden voltage drops may arise during periods of thunder and lightning. Since this could
adversely affect your computer, an uninterruptible power source (UPS) is highly recommended unless run-
ning from the battery pack alone.
l When the DC plug is not connected to the computer, disconnect the AC cord from your electrical outlet.
Power is consumed simply by having the AC adaptor plugged into an electrical outlet.
3 Open the display
1
<Only for model with keyboard base>
A Pull out the handle.
l If you do not pull out the handle before opening the display, the computer may fall over due to the
weight of the display.
B Rotate the latch (D) to the arrow direction.
C Hold the dents with both hands, and lift the display slightly.
D Hold the side of the computer with either of your hands and then lift up the display to open.
IMPORTANT
l Do not open the display wider than necessary (150° or more), and do not apply excessive pressure to the
LCD. Do not open or close the computer holding the edge of the LCD segment.