Casio EXILIM EX-Z1200 User Manual page 277

Problem
An image I shot was not
saved.
Though available lighting is
bright, the faces of people in
the image are dark.
Subjects are too bright when
shooting images in a
seashore or ski area.
Digital zoom does not work.
The zoom bar indicates zoom
only up to a zoom factor of
3.0.
Recognition of a family
member's face is not
recognized correctly, even
though the face has been
recorded.
The image is out of focus
during movie recording.
During movie recording, the
REC light keeps going out
and the monitor screen keeps
going dim suddenly.
C
1) Camera power may have been turned off before the save operation was complete, which will result in
the image not being saved. When the battery indicator shows "
possible (page 37).
2) You may have removed the memory card from the camera before the save operation was complete,
which will result in the image not being saved. Do not remove the memory card before the save
operation is complete.
Not enough light is reaching the subjects. Change the flash mode setting to "
synchro flash (page 76), or use adjust EV shift to the + side (page 141).
Sunlight reflected by water, sand, or snow, can cause underexposure of images. Change the flash mode
setting to " " (Flash On) for daylight synchro flash (page 76), or use adjust EV shift to the + side (page
141).
1) The digital zoom setting may be turned off. Turn on digital zoom (page 75).
2) Time stamping may be turned on, which will cause digital zoom to be disabled. Turn off time stamping
(page 151).
Though face characteristics were recorded for your family member, the data may have been faulty, or the
angle to the face or its expression may be making recognition difficult. Re-record the face of the family
member who is not being recognized (page 95).
1) Focusing is not possible because the subject is outside the focus range. Shoot within the allowable
range.
2) The lens may be dirty. Clean the lens (page 35).
The camera is designed to turn off the REC light and decrease the brightness level of the monitor screen
automatically whenever its temperature exceeds a preset level during movie recording. If you keep
recording under these conditions, "ALERT" will appear on the monitor screen and movie recording will stop
automatically. If this happens, turn off the camera and wait until it cools down before trying to use it again.
Possible Causes and Action
277
", charge the battery as soon as
" (Flash On) for daylight
APPENDIX