Related Manuals for ORDISI FV SM Series
Summary of Contents for ORDISI FV SM Series
- Page 1 Maintenance and Functioning manual Tecnologia 2 – nave 7 08780 Palleja Barcelona - Spain Tel. (34) 93 334 01 12 Mom-24 Fax (34) 93 440 25 64 Edición 6 comercial@ordisi.com Fecha 2020/04/024 www.ordisi.com...
- Page 2 2.- MANUFACTURER’S RESPONSABILITIES ORDISI S.A. is responsible for the correct operation and safety of this aspirator provided the following conditions are met: • The equipment is operated in accordance with this instruction manual • Parts and consumables requiring preventive replacement are replaced only with original parts and/or ORDISI S.A.
- Page 3 FRONT 1.- Luminous ON/OFF switch 2.- Vacuum regulator 3.- Vacuum gauge 4.- Vacuum connector 5.- Control panel with synoptic board 6.- Bacterial filter 7.- Collection bottle 8.- Additional 1 litre safety bottle (optional) 9.- Air Vent 10.- Transportation handle 11.- Anti-static caster wheels with breaking function. 12.- Anti-static caster wheels BACK 12.-...
-
Page 4: Installation And Operating
4.- INSTALLATION AND OPERATING 4.1.- UNPACKING Upon reception of the equipment, if package is seen as damaged, immediately check if device has been affected. If damages are confirmed, immediately refer them to sender. 4.2.- START-UP Not to use in explosive atmospheres like the anaesthetic produced ones by inflammable. Check the electrical installation of the room where the equipment is being installed, and make sure it complies with the IEC (UNE) regulations. - Page 5 4.4.- FURTHER INFORMATION CONCERNING ASPIRATOR INTENDED USE Tough surgical aspirator with large workflow capability. Because if its power and flow rate, is indicated for: • Major surgery. • Medium surgery. • Endoscopic suction. • Gynaecological suction. • Suction in hospital wards. ...
- Page 6 9.- DIAGRAMS AND SCHEMATICS ORDISI, S.A., on customer request, will supply the parts lists and their description as well as their instructions of calibration, and any other additional information that may be needed by the qualified technical staff repairing the machine.
-
Page 7: Pneumatic Diagram
9.1.- PNEUMATIC DIAGRAM 1) Pump 2) Control dials 3) Vacuum regulator 4) Vacuum gauge 5) Bacterial filter 6) Safety bottle 7) Collecting bottle 8) Towards patient 9) Air outlet 9.2.- CIRCUIT SCHEMATIC 9.3.- EXPLODED VIEW See page 9 & 10 10.- TROUBLESHOOTING FAILURE OR MALFUNCTION CAUSE... - Page 8 11.- TECHNICAL SPECIFICATION, EMC INFORMATION Guidance and manufacturer’s declaration – electromagnetic emissions The system is intended for use in the electromagnetic environment specified below. The customer or the user of the equipment SHould assure that it is used in such an environment. Electromagnetic environment –...
-
Page 9: Plano De Despiece
9.3.- PLANO DE DESPIECE Page 9 of 10... - Page 10 Page 10 of 10...