CBL/SAT
Cable box, satellite
receiver, Internet Protocol
TV (IPTV), Free To Air TV,
High Definition Television
decoder (HDTV) and TiVo
Example: setting up the universal remote
control to operate your TV:
1
Switch ON the TV manually or use the
original remote control for this. Tune to
channel 1.
2
Press and hold the
deviceselection
button for 5 seconds
until the red Setup
light
blinks.
•
The remote
control is now in setup mode.
3
Look up the 4-digit
code for your brand
in the brand list at
the back of this user
manual.
A 4-digit code is
shown for each brand.
Use the digit
buttons to enter the
code for your brand.
•
If the red Setup
light
turns off,
an invalid code
was entered. In this case, try again.
4
Aim the remote
control at the TV.
Press and hold the
button.
Release it
immediately as soon
as the TV switches off.
•
This step normally takes between 5 and
60 seconds. In extreme circumstances
this step can take up to 15 minutes.
4
EN
5 sec.
5-60 SEC.
5 - 60 sec.
5
Switch ON the TV.
Try out the buttons
you need for
operating it. Try, for
example, if the
- CH + and digit
buttons function properly.
•
If a button does not work as expected, press
and hold that button. Release it immediately
as soon as it works. For more information,
see chapter 2.2.2.
6
Press the
device selection
button twice to
finish setup.
•
When no
button is
pressed for 5 minutes or more, the
remote control will exit setup mode,
automatically saving all your settings.
Important
If you made a mistake:
Press the device selection button twice to
•
exit setup.
The red Setup light
•
Restart from the beginning.
If the device does not respond at all or not to
•
all of the button commands or if you cannot
find the code for your brand, enter '9, 9, 9, 9' in
step 3 and continue with step 4. The remote
control will now search its full database for a
code that works with your TV. Full database
search may take up to 15 minutes.
2.2.1
Setting up the remote control for
other devices (DVD player / recorder
and Cable / Satellite box)
1
Make sure the device is switched on and
operational. E.g. insert a disc in the DVD
player / recorder.
2
Then follow steps 2 to 6 of 'Setting up the
universal remote control to operate your
TV'. Make sure to use the correct device
selection button:
2 x
turns off.
or
.
EN
5