Advertisement
⚠
If a 3/8 male x female brass "flow limiting adaptor" is attached to the end of 110°C braided hose (X5) it must be
removed
⚠
The boiler flexi hose (X5) is approximately 1200mm in length, when connected to the boiler with silicone boiler
outlet hose (K) it must not be doglegged and have a constant fall from the tap to the proboil4e outlet.
17) Unscrew ½" x ½" Vent hose (B9) from ½" Safety / steam / overflow vent outlet (A7).
18) If boiler mounting bracket (A3) has been used please unscrew this now.
19) Now the Boiler (A1) has been disconnected it can now be removed from the sink unit.
1.4 PROBOIL3:
1.4 PROBOIL3: Vent, Tundish & Drain
Vent, Tundish & Drain removal
1.4 PROBOIL3:
1.4 PROBOIL3:
Vent, Tundish & Drain
Vent, Tundish & Drain
Option 1 – Removal
1)
Place a washing up bowl or bucket on the floor below the
pipework.
2) Unscrew plastic compression nut (B4) and pull parts (B5, B6,
B7, B8 & B9) away from waste tee (B2).
3) Place a blanking plug (proboil part order code SC-7158)
inside compression nut (B4) and screw tightly (B4) by hand
back onto waste tee (B2).
Option 2 – retain
1) Unscrew vent hose (B9) and remove from tundish (B8).
2) Rotate waste tee (B2) so it is out of the way.
2 2 2 2 .0 .0 .0 .0 PROBOIL4E
PROBOIL4E
PROBOIL4E
PROBOIL4E: : : : Boiler installation
Boiler installation
Boiler installation
Boiler installation
1) Please now refer to section 2.3.4 in the 'PROBOIL 4.E User and Installation Guide' for the next steps for
installation.
2) Before connecting the PROBOIL4E to the existing filter (C5) you should check that it is not past its recommended
expiry date as written on the label on filter (C5), if required it is recommended to be replaced before
continuing or shortly after installation.
⚠
3)
When reconnecting the 98°C tap hose (A8) you must not connect it directly to PROBOIL4 output port (C) directly,
you must connect the hose to the
PROBOIL3 conversation to PROBOIL4E guide v1b
removal
removal
removal
PROBOIL4E output port using silicone adapting hose (parts L,K,J & I)
⚠
Note it may still be hot to touch
Page 6
Advertisement
