Advertisement
Manual for FP Board
TIPS
1, Please try to click 5 points of screen (Pic10). Move one finger from far to close. If the finger is detected at 5mm or above before
touching the board. Please tighten No 3 and No 4 screws and loosen No 1 and No 2 screws. (For double faced adhesive tapes,
please insert the cards from the top of the base. Before adjusting the screws, please open the calibration screen first and check the
result. Keep doing this until the finger can only be detected at 2-4mm away from the whiteboard surface.
(Pic10)
2, You may see some white line marked in red circle (Pic6). It will make calibration failed.
(Pic6)
(Pic6)
If you use the screws for installation, this problem can be solved by tightening No 1 screw and loosen No 4 screw (Pic7). (White line
is located at left of screen, please tighten No 2 screw and loosen No 3 screw
White lines are located at left and right screen, please loosen No 3, 4 screws and tighten No1, 2 screws)
Please keep trying until the white line gone.
14
Advertisement
