Matco Tools MDMAXFLEXPRO Quick Start Manual

MAXFLEXPRO Tablet
The tablet acts as the central processing system, which is used to receive and analyze the live
vehicle data from the VCI dongle and then output the test result.
Data Transmission Port
(Reserved for add-on
modules, and
other USB devices use only.)
Memory Card Slot
(To store the memory card
for storage extension.)
Charging Indicator
(Red means Charging, and
Green means Fully Charged.)
Microphone
10.1" Touch Screen
Rear Camera
Audio Speaker
Foldable Stand
(Flip out it to any angle and work comfortable
at your desk, or hang it on steering wheel.)
VCI (Vehicle Communication Interface)
The VCI dongle works as a vehicle communication interface device, which is used to connect
to the vehicle's DLC (Data Link Connector) port via the diagnostic cable to read the test data
and then send it to the tablet.
After use, please remember to unplug it from the DLC port.
DB-15 Diagnostic Connector
(To connect the diagnostic cable.)
LED Indicators
It is defined as follows:
1. Power: It illuminates solid red when the VCI dongle is
powered on.
2.Vehicle Communication: While the VCI dongle is
communicating with the vehicle, the LED lights up
and flashes. Otherwise, it will not illuminate.
3.Tablet Communication:
ž
It illuminates blue when the VCI dongle is working in
wireless (BT) communication mode.
ž
It illuminates red when the VCI dongle is connected
to the tablet via data cable (not included).
Data I/O Port
(To connect it to the tablet to perform
diagnosis via the data cable.)
*Note: When the VCI dongle is connected to the tablet via data cable (not included), the
system will switch to USB mode automatically and the wireless communication will be
disabled.
Type-C Charging Port
(Reserved for charging or transferring data.)
Power/Screen
Lock Button
Volume Buttons
Ambient Light Sensor
Microphone
Front Camera
Camera Flash
Audio Speaker
Quick Start Guide
Included Accessory Checklist
MAXFLEXPRO Tablet
A tablet for showing test results.
Power Adapter
To supply power to the tablet
through connection to AC outlet.
Password Envelope
A piece of paper bearing
Product S/N and Verification Code,
which is required for your VCI
activation.
Quick Start Guide
Working Principle
The following illustration demonstrates how the MAXFLEXPRO diagnostic system works.
MAXFLEXPRO Tablet
Internet
Wi-Fi
*Note: If the VCI dongle is successfully activated, the tablet will
automatically obtain the VCI ID and connect to it. In this case it is
not necessary for the user to manually configure it again. For
details on how to activate the VCI dongle, refer to Section 4.
Register & Update.
Motorcycle
1. Charging & Turning On
1. Connect one end of the included power adapter to Type-C charging port of the tablet, then
connect the other end to the AC outlet.
*Warning: Please use the included power adapter to charge your tablet. No responsibility
can be assumed for any damage or loss caused as a result of using power adapters other
than the one supplied.
2. After charging is complete, disconnect the power adapter from the AC outlet. Press
the

[POWER]
button on the
tablet , the system starts initializing and then enters the home screen.
MDMAXFLEXPRO
Vehicle Communication Interface
(VCI) Dongle
A device for accessing vehicle data.
Diagnostic Cable
To connect the VCI dongle and the
test vehicle.
MDMAXFLEXPRO
VCI Dongle
BT
or
To Vehicle's DLC Port
Car
2202032-16
Power
Vehicle Communication
Tablet Communication
2202032-16