Channel Selection - Advent Q1435A Instruction Manual

Operations

Channel Selection

AV/TV MENU VOL- VOL+
1 2
4 5
1
7 8
0
AV
CH
CCD
MENU
SLEEP
PIC MODE
CH
13
Before you select a channel, please select AIR or CABLE input signal.
5
Please see the section of "Setting AIR/CABLE option ".
When you select AIR, only channels received on antenna can be selected;
When you select CABLE, channels received on cable can be selected.
1
Use Direct Channel Selector (0-9 buttons)
To select one-digit channel:
F
CH- CH+
To select two-digit channel:
F
2
To select three-digit channel:
F
3
6
2
9 Use CH+ or CH- button
Press
3
Press
DSP
3
Use previous channel
2
Press this button to switch between the current channel and the
previous channel.
Notes:
If you select
option
indicates that the current input signal is from
Press 0-9 digit buttons and wait for 3 seconds. For example,
you need channel 5, please input "5" button and the screen
displays "5-", the TV set goes to channel 5 in 3 seconds
Press two digit buttons in order to input the channel number. For
example, you need channel 20, please input "2" button,
followed "0" button and the set goes to channel 20. Be sure that
the second press should be within 3 seconds.
Press three digit buttons in order to input the channel number.
For example, you need channel 110, please input "1" button
twice, followed "0" button and the set goes to channel 110. Be
sure that the second and third press should be within 3 seconds.
CH+ button, the channel number increases;
CH- button, the channel number decreases.
CABLE input in the section of "
", then a letter " " appears with the channel number, which C
button
Setting AIR/CABLE
CABLE .