Table of Contents
Advertisement
NLBasic settings
Basic setting
Water connection
Eco forecast
EmotionLight
time light
Launcher
Signal strength
Key Volume
WiFi
1
Factory setting (may differ depending on the device type)
40
Choice
Cold water
1
hot water
On
Out
1
Out
on via
main switch
1
On when opening
door
On
1
Out
Eco 50°C
1
Last selected program
Scale with multiple
positions.
Scale with multiple
positions
On
Out
Description
Set cold water connection or hot water
connection.
Only set the device to Hot water if the hot water is
prepared in an energy-efficient manner and if a
suitable installation is available, e.g. a solar
cylinder with a circulation line. The water
temperature must be a minimum of 40 °C and a
maximum of 60 °C.
Turn Eco Forecast on or off.
During program selection, the average water
and energy consumption is briefly shown in
the display.
Switch the interior lighting of the device
on or off.
The interior lighting switches off automatically
after 10 minutes when the door is open.
Enable or disable "Timelight". During the program
run, status information such as the time
remaining is projected on the floor below the
appliance door. The indication is not visible with a
pre-inserted plinth plate or with a high installation
with a flush-fitting furniture front.
Set the default program when the
device is switched on.
"Programs", Page 20
Set the signal volume at the end of
the program.
At position 0 the sound signals are switched off.
Set the key volume during operation. At
position 0 the key signals are switched off.
Enable or disable wireless network
connection.
The basic setting "Wi-Fi" is only available after
you have connected the appliance with the
Home Connect app.
"Home Connect", page 41
Advertisement
Table of Contents
