Switching Off Water Softening; Softening System Regener; Run; Rinse System - Bosch SBV8ZCX02E User Manual

Table of Contents

Advertisement

NLRinse System
Switch off water softening
If the refilling salt indicator bothers
you, for example if you use a
combined dishwasher detergent with
a salt component, you can switch off
the softening salt indicator.
Remark
To avoid damage to the
appliance, only switch off the
water softening in the following
cases:
†The water hardness is maximum
times 21 °dH and you use a
combined dishwasher detergent
with salt substitutes. According to
the manufacturer's instructions,
combined dishwasher detergents
with salt substitutes can only be
used up to a degree of hardness of
21 °dH without adding softening
salt.
†The water hardness is 0 - 6
°dH. You do not need to use
softening salt.
Press.
1.
Approx. Press for 3 seconds to access
2.
the basic settings.
Press repeatedly until the display
3.
shows "Water hardness".
Press or repeatedly until the display
4.
shows 0 - 6.
To save the settings, press for
5.
approx. 3 seconds.
aThe water softener has been
switched on and the refill
softener salt indicator is
deactivated.
30
Regenerate the softening
system
In order to maintain trouble-free
operation of the water softening system,
the device regularly performs a
regeneration of the water softening
system.
The softening system is regenerated in
all programs before the end of the
main wash cycle. This increases the
running time and consumption values
of, for example, water and electricity.
Overview of the consumption values
when regenerating the
softening system
Here you will find an overview of the
maximum additional runtime and
consumption values when regenerating
the softening system.
Regenerating the softening
system after x washes
Additional running time in minutes
More water consumption in litres
More power consumption in kWh
The stated consumption values are
laboratory measured values which
are determined according to the
currently valid standard and on the
basis of the Eco 50° program and the
factory-set water hardness value of 13
- 16 °dH.

Rinse System

rinse aid

For optimal drying results it is best
to use the rinse aid.
Only use rinse aid for household
dishwashers.
6
7
5
0.05

Advertisement

Table of Contents
loading

Table of Contents