Electrolux EQBW316AS User Manual

Integrated burner


Quick Links

Integrated burner


Table of Contents

Summary of Contents for Electrolux EQBW316AS

  • Page 1 USER MANUAL Integrated burner EQBW316AS...
  • Page 2: Table Of Contents

    WE’RE THINKING OF YOU CONTENTS Thank you for purchasing an Electrolux barbecue. General warnings You’ve chosen a product that brings with it decades Electrolux Integrated burner product description of professional experience and innovation. Ingenious Gas specifications and stylish, it has been designed with you in mind.
  • Page 3: General Warnings

    Read the following carefully to avoid damage or injury. manual. If the leak persists, turn off the gas supply and call Electrolux Service Centre or a Licensed Gas Fitter. NOTE! You must read these warnings carefully before installing or using the appliance. If you need assistance, contact your Customer Care Department.
  • Page 4 INTEGRATED BURNER Slimline lid Gas connection point...
  • Page 5 Pivoting lid safety leg Lid mounting bracket Trivet Burner Burner control Reversible cast grill plate...
  • Page 6: Gas Specifications

    GAS SPECIFICATIONS GAS CONNECTION DETAIL Gas type Natural gas Universal LPG Maximum gas 22 MJ/h 23 MJ/h consumption Injector orifice 2.10mm 1.25mm diameter (mm) Number of injectors Regulator pressure 1.00 kPa 2.75 kPa NOTES: • This appliance MUST be installed and serviced only by a qualified licensed person.
  • Page 7: Universal Lpg Installation

    UNIVERSAL LPG INSTALLATION GAS BOTTLE SAFETY INFORMATION This barbecue is supplied set up for Universal LPG and • This appliance is designed to use a 9kg (20 lbs) is labelled accordingly. A Natural Gas conversion kit is gas cylinder. available if required. Refer to Natural Gas installation •...
  • Page 8: Natural Gas Installation

    Compliance must be issued to the owner on completion are available as an accessory and can be purchased either of the installation and conversion. on the Electrolux spare parts website or by contacting the Electrolux Customer Service Centre. Refer to Accessories section on page 17 for part numbers.
  • Page 9 2. Remove two screws fastening burner. 5. Replace burner and cover panel. 6. Remove LPG sticker on the base panel and replace with natural gas sticker provided. Screw The final step in the conversion of the barbecue to Natural Gas is the adjustment of the turndown setting. This can only be completed after the barbecue has been connected to a supply of natural gas.
  • Page 10: Leak Test Procedure

    NATURAL GAS INSTALLATION LEAK TEST PROCEDURE Preparing the unit for Natural Gas connection • Ensure gas valve is in the ‘OFF’ position. to mains • In a small container, mix a solution of water and detergent or soap. Natural gas connection to be made by a licensed gas fitter. •...
  • Page 11: Installation Warnings

    INSTALLATION WARNINGS INSTALLATION INSTRUCTIONS When planning the location and preparing the installation WARNING! structure for this appliance note the following: • This appliance shall only be used in an above ground, • This appliance must be installed in accordance with open air situation with natural ventilation, without Australian Standard AS 5601 and in accordance with stagnant areas, where gas leakage and products of...
  • Page 12 Dimensions Side view - lid up 71mm min. From cutout Side view - lid down Bench width 600mm min. 540mm Vent 250mm x 25mm (required when installed separately to barbecue) WARNING! • This appliance requires venting. This vent is to allow air into the enclosure for the correct combustion of gases and for the correct exhausting of the products of combustion.
  • Page 13: Gas Requirements

    GAS REQUIREMENTS LOCATING INTEGRATED BURNER ADJACENT TO INTEGRATED BARBECUE Natural Gas requirements • The enclosure must be constructed so that access can be gained to the Natural Gas regulator at all times. • For pipe sizing requirements for supply pipe refer to AS5601.
  • Page 14: Connecting With Electrolux Integrated Barbecue

    CONNECTING WITH ELECTROLUX INTEGRATED BARBECUE Reversible cast grill plate The integrated burner features a reversible grill plate If the integrated burner is located adjacent to the built in designed specifically to sit onto the cast iron trivet, ensure barbecue and the units are to be connected to the same the plate is centered over the burner before operation.
  • Page 15: Burner Operation

    BURNER OPERATION PIVOTING LID SAFETY LEG Control functions To ensure that the user remembers to turn off the gas before closing the lid, a pivoting safety leg has been fitted. Before lighting the burner: • Check that all hoses and gas fittings are tight. •...
  • Page 16: Cleaning And Care

    You will • This appliance contains brass and aluminium fittings. find these cleaners at Electrolux spare parts outlets. Do not use caustic based cleaners Burners • Do not use steam cleaners as this may cause moisture build up on electrical components.
  • Page 17: Troubleshooting

    Check for leaks, via the Electrolux Customer Service Centre. ATTEMPT TO LIGHT THE tighten joints * Sold separately via the Electrolux Customer Service Centre. For the full APPLIANCE range of accessories please visit electrolux.com.au or electrolux.co.nz If problem persists call Electrolux Service...
  • Page 18 NOTES...
  • Page 19: Warranty

    Australia or New Zealand. failure and for compensation for any other reasonably foreseeable loss or 3. During the Warranty Period Electrolux or its ASC will, at no extra charge damage. You are also entitled to have the Appliance repaired or replaced...
  • Page 20 0800 234 234 fax: 0800 363 600 email: customercare@electrolux.co.nz web: electrolux.co.nz Electrolux. Thinking of you. Share more of our thinking at electrolux.com.au or electrolux.co.nz P/No. A03569201 RevA © 2015 Electrolux Home Products Pty Ltd. ABN 51 004 762 341 EMAN_INTBURNER_Jun15...

Table of Contents