Table of Contents
Advertisement
3. Clean the burner chamber with a cloth soaked in
detergent or with non-scratching, soft brush. Ensure
that no food remains are left.
4. Clean the spark plugs and thermal elements (in
models with ignition and thermal element) with a
well squeezed cloth. Then dry with a clean cloth.
Pay attention that the spark plug and the thermal
element are completely dry.
5. Clean the burner caps and heads with detergent
water after each operation and then dry them.
6. For persistent stains, keep burner caps and heads
in detergent water or warm soapy water at least for
15 minutes. Clean with a non-metallic and non-
scratching brush.
7. You may use the Quick&Shine cleaning agents for
the oven interiors and grills, used on enamelled
surfaces and recommended by the authorized
service, especially for persistent stains on
enamelled burner caps.
8. Do not contact burner caps with aggressive
detergents such as oven interior cleaning agents,
descalers while cleaning them, this may cause
discolouration.
9. Clean the pot holders with detergent water and non-
scratching, soft brush after each operation and then
dry them.
10. When the burner caps and pot holders are used
as wet, persistent lime stains may occur as a result
of the heat. Ensure that it is dried before operation.
11. Place burner heads, caps and pot holders
respectively.
12. When placing the pot holders, ensure that they
centre the burners.
Assembling the burner parts
Place the parts as in the figure after cleaning the
burners.
1
Inner burner cap
2
Outer burner cap
3
Burner head
4
Burner chamber
5
Injector
6
Spark Plug (in products with igniter)
7
Thermic element (in products with thermic
element)
21/EN
Advertisement
Table of Contents
