Table of Contents
Advertisement
Connecting the gas hose For LPG
•
Have your product connected in a way that it will
be close to the gas connection and not gas
leakage will exist.
•
Plastic hose to be used must not be longer than
125 cm.
•
Install the clamp to the hose. Soak one end of
the hose (15 mm inner diameter) into boiling
water for one minute to soften it.
•
Than, slip the softened end of the hose
completely onto the sharp hose tip of your
product. Finally, tighten the clamp completely
with a screwdriver.
•
Repeat the same procedure for the other end of
the hose and complete the gas cylinder
connection.
•
Never forget to make the gas leakage control.
DANGER:
Risk of explosion and suffocation!
Do not keep LPG cylinders in home.
•
If you need to use your product later with a
different type of gas, you must consult the
Authorised Service Agent for the related
conversion procedure.
1
LPG hose tip
2
Plastic hose
Leakage control at the connection point
•
Make sure that all knobs on the product are
turned off. Make sure that the gas supply is open.
Prepare soapy foam and apply it onto the
connection point of the hose for gas leakage
control.
•
Soapy part will froth if there is a gas leakage. In
this case, inspect the gas connection once again.
Never use a match or lighter to make the gas
leakage control.
If there is a built-in oven installed under the hob;
•
Gas hose must be routed in a way that it will not
touch the oven, sharp edges or corners beneath
the hob, or will not be kinked or twisted.
If you will make the gas connection from left
hand side when viewed from your position, fix
the hose with clamps.
1
Bottom view
2
Hose tip
3
Hose
4
Clamp
5
Oven
Installing the product
1. Remove burners, burner caps and grills on the
hob from the product.
2. Turning the hob upside down, place it on a flat
surface.
3. In order to avoid the foreign substances and
liquids penetrate between the hob and the counter,
please apply the putty supplied in the package on
the contours of the lower housing of the hob but
make sure that the putty does not overlap.
4. Fill the corners by forming bends at the corners as
illustrated in the figure. Form as much bend as
required to fill the gap in the corners.
Make sure that the skirting sections on
the lower housing of the hob are filled
with putty.
5. Turning the hob again, align and place it on the
counter.
6. You can secure your hob to the counter by using
the clamp and the screws supplied.
15/EN
Advertisement
Table of Contents
