Toshiba B-SA4TP Series Instructions Manual page 2

2. Take out the Media Holder Ass'y from the printer.
3. Raise the Release Lever and remove the Media Holder
(Left).
4. Insert the Media Shaft into the core of a media roll.
NOTE:
When the inner core diameter of the media roll is
40mm, remove the Spacers from the Media Holders.
5. Put the Media Holder (Left) onto the Media Shaft. Push
the Media Holder (Left) and the Media Holder (Right)
against the media until the media is held firmly in place.
This will automatically centre the media.
6. Fold the Release Lever to lock the Media Holder (Left).
Media Holder
Ass'y
Upper Sensor
Ass'y
Media Holder (Left)
Release Lever
Media Holder
(Left)
Release Lever
2
Media Shaft
Spacer
Media Holder
(Right)
Media Holder
(Left)