Troubleshooting & Faqs; Auto Button Doesn't Function; No Picture (Power Led Not Lit); Image Is Not Centered - Philips 221V2 User Manual

7 Troubleshooting & FAQs
7.1 Troubleshooting
This page deals with problems that can be
corrected by a user. If the problem still persists
after you have tried these solutions, contact Philips
customer service representative.
Common Problems

No Picture (Power LED not lit)

• Make sure the power cord is plugged into
the power outlet and into the back of the
monitor.
• First, ensure that the power button on the
front of the monitor is in the OFF position,
then press it to the ON position.
No Picture (Power LED is green)
• Make sure the computer is turned on.
• Make sure the signal cable is properly
connected to your computer.
• make sure the monitor cable has no bent
pins on the connect side. If yes, repair or
replace the cable.
• The Energy Saving feature may be activated
Screen says
• Make sure the monitor cable is properly
connected to your computer. (Also refer to
the Quick Set-Up Guide).
• Check to see if the monitor cable has bent
pins.
• Make sure the computer is turned on.

AUTO button doesn't function

• The auto function is applicable only in
VGA- Analog mode. If the result is not
satisfactory, you can do manual adjustments
via the OSD menu.
Note
The Auto Function is not applicable in
DVI-Digital mode as it is not necessary.
Visible signs of smoke or sparks
• Do not perform any troubleshooting steps
• Disconnect the monitor from mains power
source immediately for safety
• Contact with Philips customer service
representative immediately.
Imaging Problems

Image is not centered

• Adjust the image position using the "Auto"
function in OSD Main Controls.
• Adjust the image position using the Phase/
Clock of Setup in OSD Main Controls. It is
valid only in VGA mode.
Image vibrates on the screen
• Check that the signal cable is properly securely
connected to the graphics board or PC.
Vertical flicker appears
• Adjust the image using the "Auto" function
in OSD Main Controls.
• Eliminate the vertical bars using the Phase/
Clock of Setup in OSD Main Controls. It is
valid only in VGA mode.
39