Table of Contents
Advertisement
Quick Links
CG-100/130AR
Installation instructions for the legs
Introduction
This manual explains how to assemble the legs with the main unit. Be sure to read this manual before
assembling.You can also use your smartphone to scan the QR code below and view the 3D Instruction while
assembling the product.
Be sure to assemble with two or more people.
Accessories
If there is a shortage of parts or a problem, please contact your local distributor or MIMAKI sales office.
Leg x2
Roll bar x2
Screws (M5x25) x4
How to tighten the screws
1
Use hex wrench to temporarily tighten the
screws (just tighten lightly).
© 2021 MIMAKI ENGINEERING CO.,LTD.
Caster holder x2
Roll stay Right x1
Screws (M5x15) x 14
Leg stay x1
Roll stay Left x1
Hexagonal wrench
Screws (M5x16) x4
2
Push the hex wrench into the tightening pipe
and retighten the screw.
- 1 -
Base plate S x 2
Tightening pipe x 1
(4mm)x 1
Roll holder x2
Advertisement
Table of Contents
Related Manuals for MIMAKI CG-AR Series
Summary of Contents for MIMAKI CG-AR Series
- Page 1 Be sure to assemble with two or more people. Accessories If there is a shortage of parts or a problem, please contact your local distributor or MIMAKI sales office. Leg x2 Caster holder x2 Leg stay x1...
- Page 2 • Assemble the right and left legs. Remove the cushioning material and turn the legs back in their original direction. Pay attention to the mounting direction. © 2021 MIMAKI ENGINEERING CO.,LTD. - 2 -...
- Page 3 • Set the other side in the same way. Front Attach the leg stay so that the openings of the left and right legs are on the inside. No gap Lock the casters. © 2021 MIMAKI ENGINEERING CO.,LTD. - 3 -...
- Page 4 If it gets stuck or has trouble rotating, loosen the screws that have been tightened, adjust the left and right legs so that they are parallel, and then tighten the screws. © 2021 MIMAKI ENGINEERING CO.,LTD. - 4 - D203591-10-20122021...
Need help?
Do you have a question about the CG-AR Series and is the answer not in the manual?
Questions and answers