Advertisement
MOUNTING
Desk-top mounting on GFW-S stand
1. Separate mounting bracket on
back of the unit.
4. Place protection cover on
terminal section.
Wall-mounting
It is suggested to mount the station so that the LCD display comes at the user's eye level.
Modular
plug
1. Attach the mounting bracket to Single-gang box.
2. Connect wires on terminal block.
3. Mount the unit on mounting bracket.
WIRING
Terminal block
( from left R1, R2; R1, R2; C, CE; SW, SW)
GF-MK Back view
2. Attach mounting bracket to
GFW-S stand as shown.
5. Insert prongs of bracket and
slide upward until locked.
Mounting
bracket
Single-gang box
83.5mm (3-5/16")
OR
60mm (2-3/8")
Round gang-box
SW, SW:
(Non-polarized)
C, CE:
(Non-polarized)
R1, R2:
(Non-polarized)
R1, R2:
(Non-polarized)
3. Connect wires on terminal block, putting wires neatly in the slot.
Unit cable with stand hook by convex to prevent to death by
pulled out.
Screw ( 4) supplied
with GFW-S
Notes;
To detach terminal block;
Unplug
Strip cable jackets, and put all the wires neatly
into slot, otherwise damages the wires by
pinching.
Cable slot
to User-option device
to Doorbell button
to Second GF-MK
R1
R2
to Distribution point
- 7 -
GFW-S (not included)
PACKAGE CONTENTS
• Desk-top stand (GFW-S)
• Packet of screws
• Convex
Terminal block
Slide and pull out the terminal block.
Cut out a hole for surface cable run.
GF-1DK
R1
R2
C
to Doorbell
CE
PANIC CALL
K
KE
switch
to next GF-1MDK
to Doorbell
GF-1MDK
B1 B2 B1 B2
R1 R2 R1 R2
C CE K KE
IN
OUT
OUT
IN
GF-VBC
GF-BC
R1
R2
（＊）PANIC CALL switch: locally available
（w/break contact）
( )
PANIC CALL
switch
( )
Advertisement
