F700
4. Technical Specifications
•
Operating pressure: 2.5–5 bar [36.2-72.5 PSI].
•
Flow rate – 1 m3/hr [4.4 U.S.GPM] (at operating pressure range).
•
Sampling time – 6 min. periods.
•
Inlet /outlet connector – 15 cm. [½"].
5. Installation
The suspended solids sampler requires a well mixed sample of untreated
water, and unrestricted flow through the sampler. The sampler should be
installed with the body (3) oriented in vertical direction (the sample tube
(4) is oriented downwards), while the inlet (2) is horizontal and located at
the level of the supply line (1).
A 15 cm. [½"] hose, 120 cm. [47"] long should be connected to the outlet
(5) of the sampler.
The opposite end of the hose should be open to the atmosphere, in a place
that splashing water would not cause any damage or danger. In this setup
the water that will flow through the sampler is restricted to approximately
1 m3/hr, and a sampler collects well mixed sample of the untreated water.
It is recommended to install a valve at the outlet of the sampler.
CORRECT
4