Table of Contents
Advertisement
4 Use the headset
Connect the headset to your mobile phone
1
With the mobile phone turned on, press
up, to turn on the headset.
Once turned on, the headset reconnects automatically to
»
the last device it was connected to.
»
If the last connected device is not available, the headset
tries to reconnect to the second to last device that was
connected to the headset. If it cannot find this device, it
will look for all previously paired devices in the order of
last usage, until it finds a device to connect to. The headset
stores up to three previously paired devices.
Tip
•
If you turn on the mobile phone or its Bluetooth feature
on the headset, connect the headset from the Bluetooth menu of
your mobile phone.
Automatic power saving
If the headset cannot find any Bluetooth device to connect to in
range within five minutes, it automatically powers down to save
battery life.
Get the best fit
1
Choose the earbuds that best fit for your ear canal.
2
Gently blend the ear hook to fit into your ears.
3
Adjust the rubber part of the ear hook to the height that you
feel fit.
4
Twist the earbuds to the right position for best fit and noise
isolation.
Operate the headset
Enter pairing mode
Check battery
until the LED lights
Turn headset on/off
Play/Pause music
Stop music
Next / Previous track
Adjust volume
Pick up / End a call
Reject a call
Redial the last number
Activate voice dialing*
after turning
Mute/Unmute the Mic
Transfer a call to a
mobile phone
* Available if supported by your mobile phone.
Manage 3-way calls
If your mobile phone and network operator support 3-way-calls, you
can manage 3-way-calls via the headset.
To hold the active call and
accept a waiting call
To drop the active call and
accept a waiting call
To swap a call
LED and sound indication
The red/blue LED flashes alternately. The headset is ready for
The blue LED flashes once every 6
seconds.
The blue LED flashes twice every 3
seconds.
The blue LED flashes once every half
a second.
The blue LED flashes once every
second.
The red LED flashes three times and
beeps twice every minute.
Solid red LED.
The LED is off.
The headset beeps every 5 seconds. The Mic is muted.
Clean the headset
A few ways to clean the headset:
•
•
•
Ensure the headset is off. Press
LED starts blinking red/blue alternately.
When first use: Hold
During operation: Hold VOL + and VOL
- simultaneously.
>50%: 1 blue flash
>25%: 2 red flash
<25%: 3 red flash
Hold
until LED turns on/off.
Tap
Hold
Tap
/
Press VOL +/VOL -
Tap
Hold
Press twice quickly.
Hold until beep occurs.
Double tap during a call.
Hold
Wipe with clean cloth.
Wash it under running tape water.
Caution
Do not dive with this product or immerse it into water.
until
for 2 seconds.
during a call.
Press while the 2nd call is
coming in.
Hold while the 2nd call is
coming in.
Press during a call.
pairing.
The headset is connected
to the device.
The headset is not
connected.
There is an incoming/
outgoing call.
The headset is active on
a call.
The battery is low in
power.
The headset is charging.
The headset is off./Charging
is finished.
EN
7
Advertisement
Table of Contents
