Kawai CN201 Owner's Manual page 36

Appendix
1. Attaching B and C to E
① Unfasten the pedal cable attached to E (one location only)
and extend the cable.
② Take the screws temporary mounted in E and set each one to
the metal groove of B and C, respectively.
③ Make sure that B and C are pressed against E without a gap.
Then, fasten the temporary mounting screws.
④ Insert the four silver tapping screws d into the rest of the
holes. Tighten the screws to secure the panels in place.
③
B
E
Gaps
B
E
①
Pedal cable
B
④
d
36
B
E
B
E
E
B
E
②
③
Temporary mounting screw
2. Attaching D
① Allow the E assembled with B and C to stand upright as
shown in the figure below.
Ensure that the adjustor is attached and the floor is
clear from parts or musical notes.
② Align the screw hole position of D to that of B and C. Use two
pieces of the long black tapping screws b to set them in
place temporarily.
③ Align the screw hole position of D and E. Use four pieces of
the short black tapping screws c to secure them in place.
④ Ensure that B and C are aligned with D without a gap, and
then fasten the temporarily mounted b long black tapping
screws* to keep them in contact.
* For some of the body colours, silver screws are provid-
ed instead of black screws.
①
Adjustor
C
C
b
c
Not aligned
B
②
b
D
c
c
c
③
④