User Guide; Location Of Controls; Overheating Safe Device; Cleaning - HOMCOM YH-20-1A Installation And User Instruction Manual

Model Voltage
YH-20-1A 120V

User Guide:

Location of Controls

1. Thermostat control knob (TEMPERATURE SETTING)-Adjust to maintain room
temperature
2. Flame switch - Switches flame effect and power on/off
3. Heating setting: please press "
4. Heating setting : please press "
without first press "
5. Flame dimmer control - Adjust to set flame intensity
If the heater stops working, turn the heater off and inspect the blockage of inlet or outlet.
Disconnect the plug and wait at least 10 minutes for the protection system to reset
before attempting to restart the heater. If the safe device still switches the heater off and
makes the heater fail to operate, take the heater to your nearest service center for
examination or repair.
Attention: before restarting the heater, the plug must be disconnected for at least 10
minutes

Cleaning

1. Always disconnect the appliance from the main supply before cleaning.
2. Clean the outside of the heater by wiping with a damp or dry cloth.
3. Do not use petroleum, any other detergent or chemical solvent to clean the heater.
4. When the heater is not used for a long time, it should be protected from dust and stored
in a clean dry place.

Disposal

Environmental Protection

Waste electrical production should not be disposed of with household waste.
Please
retailer for recycling advice.

Fireplace Heaters

Frequency
60Hz
" for 750W
" and "
")

Overheating safe device

recycle where facilities exist. Check with your Local Authority or
" at the same time for 1500W(can not operate
Power
1500W