PRGR HS-130A User Manual page 8

The club head speed immediately before impact and the ball speed after impact are measured
simultaneously, after which they are displayed along with the smash factor and estimated flight
distance on the LCD screen. Estimated flight distance can be switched between "Carry" and "Total"
flight distance modes.
(1) Turning on the power
* See "Turning On the Power" on pg. 6
(2) Selecting modes
・ Press and hold the MODE button for approximately 2 seconds to change modes and select
Golf mode
* Continuously pressing the MODE button will scroll through the four modes in order.
(3) Selecting the club number to be used
・ Quickly press the ENTER button.
⇒ The club number displayed at the top-right of the screen will blink.
・ Use the Scroll buttons to switch club numbers.
・ Complete the selection by pressing the ENTER button.
* If using for an approach shot, select between "PW," "AW," or "SW." Using other settings may
result in measurements not being performed correctly.
* If club number settings are not performed, the flight distance may not be estimated
correctly.
(4) Setting up the device
Set up the device as shown below.
* Set the device on a flat surface and make sure there are no obstructions between the device
and the ball.
* Correct measurement will not be possible if the device is set up in a different direction from
the launch direction, or if set up at the incorrect height.
* The same setup method can be used for left-handed players.
Launch direction
(5) Swinging
After the club is swung, the results will be shown on the LCD screen.
* When data updates, the display on the LCD screen will blink.
* Measurements will not be possible while the display is blinking. Wait until the display stops
blinking before swinging again.
Measuring
.
(Golf Mode)
3.5 ft. - 5 ft.
Measurement area
7