Pantech AT&T P2030 User Manual page 98

can radiate radio frequency
energy and, if not installed
and used in accordance with
the instructions, may cause
harmful interference to radio
communications. However, there
is no guarantee that interference
will not occur in a particular
installation. If this equipment
does cause harmful interference
to radio or television reception,
which can be determined by
turning the equipment off and
on, the user is encouraged to
try to correct the interference
by one or more of the following
measures:
190
Reorient or relocate the receiving
antenna.
Increase the separation between
the equipment and receiver.
Connect the equipment into
an outlet on a circuit different
from that to which the receiver is
connected.
Consult the dealer or an
experienced radio/TV technician
for help.
Statement according to FCC
part 15.21
Modifications not expressly
approved by this company
could void the user's authority to
operate the equipment.
RF exposure FCC
For body worn operation, to
maintain compliance with FCC
RF exposure guidelines, use
only accessories that contain
no metallic components and
provide a separation distance
of 20mm (0.7 inches) to the
body. Use of other accessories
may violate FCC RF exposure
guidelines and should be
avoided.
This device and its antenna must
not be co-located or operating
in conjunction with any other
antenna or transmitter.
Appendix
Health and Safety
Information FCC
This EUT has been shown to
be capable of compliance for
localized specific absorption
rate (SAR) for uncontrolled
environment/general population
exposure limits specified in ANSI/
IEEE Std. C95.1-1992 and had
been tested in accordance with
the measurement procedures
specified in FCC/OET Bulletin 65
Supplement C (2001) and IEEE
Std. 1528-2003 Ministry of Health
(Canada), Safety Code 6. The
standards include a substantial
safety margin designed to
01
02
03
04
05
06
01
02
03
04
05
06
07
191