Fcc Regulatory Compliance - Pantech AT&T P2030 User Manual

in Section 20.19 of the FCC
Rules. The HAC rating and
measurement procedure are
described in the American
National Standards Institute
(ANSI) C63.19 standard.
To ensure that the Hearing Aid
Compatibility rating for your
phone is maintained, secondary
transmitters such as Bluetooth
and WLAN components must be
disabled during a call. See page 81
for instructions to disable these
components.
188
FCC Regulatory
Compliance

FCC Regulatory Compliance

This device complies with Part
15 of the FCC Rules. Operation
is subject to the following two
conditions: (1) this device may
not cause harmful interference,
and (2) this device must accept
any interference received,
including interference that may
cause undesired operation.
Your mobile device is a low power
radio transmitter and receiver.
When it is ON, it receives and also
sends out radio frequency (RF)
signals.
In August 1996, the Federal
Communications Commission
(FCC) adopted RF exposure
guidelines with safety levels for
mobile devices.
Those guidelines are consistent
with safety standards previously
set by both U.S. and international
standards bodies: American
National Standard Institute
(ANSI), National Council of
Radiation Protection and
Measurements (NCRP), and
International Commission
on Non-Ionizing Radiation
Protection (ICNRP). Those
standards were based on
Appendix
comprehensive and periodic
evaluations of the relevant
scientific literature. The design
of your phone complies with the
FCC guidelines and applicable.
Statement according to FCC
part 15.105
NOTE: This equipment has
been tested and found to
comply with the limits for a
Class B digital device, pursuant
to Part 15 of the FCC Rules.
These limits are designed to
provide reasonable protection
against harmful interference
in a residential installation. This
equipment generates uses and
01
02
03
04
05
06
01
02
03
04
05
06
07
189