Download Print this page

Hercules SC-190 Instruction Book

Hot-knife cutter for styrofoam

herculescutters.com

SC-190

Hot-Knife Cutter

for Styrofoam

Designed for intermittent-use cutting of Expanded Polystyrene (EPS), Extruded

Polystyrene (XPS), Polyethylene, Cross-Linked Polyethylene, Polypropylene, and many

other foamed plastics and materials can be easily cut with the SC-190 Hot-Knife

Styrofoam Cutter. Always check with the foam manufacturer for safe and proper cutting

Table of Contents

Need help?

Do you have a question about the SC-190 and is the answer not in the manual?

Page 1 Designed for intermittent-use cutting of Expanded Polystyrene (EPS), Extruded Polystyrene (XPS), Polyethylene, Cross-Linked Polyethylene, Polypropylene, and many other foamed plastics and materials can be easily cut with the SC-190 Hot-Knife Styrofoam Cutter. Always check with the foam manufacturer for safe and proper cutting...
Page 2 OTHER PRECAUTIONS • The SC-190 Hot-Knife blades have a sharpened razor edge. For the cleanest cut, always cut in the direction on the sharpened edge. • Excessive power output and heat generation may cause the blade holders to overheat resulting in damage to the unit.
Page 3 UTTING CCESSORIES SLED This hot-knife sled enables you to make thousands of different shapes and elaborate cuts by using our flat 12” blade (Part# 7729) that can be custom shaped with our wire bending pliers (Part# 7740). Built-in guide helps you make a smooth and accurate cut every time. Part # 7726 CUTTING GUIDE This hot-knife cutting guide allows...
Page 4 2. Slide the blade under the square pressure plates until snug. 3. Securely tighten screws to assure the proper electrical connection. Do not over-tighten. 4. Once the blade is firmly in place, plug your SC-190 Hot-Knife Cutter unit into a standard 110 volt AC power supply.