ACO SplashLight Installation Instructions

ACO SplashLight
Installation Instructions
Product Description
ACO SplashLight contains two low-voltage
battery-operated LED units which fit directly
into the ACO ShowerDrain Premium channel
grating. These units will illuminate once they
come in contact with water and will come off
approximately two minutes after the shower is
turned off.
Charging ACO SplashLight
The LED unit must be fully charged before
installing for the first time. Make sure the LED
unit is clean and dry, then insert it into the
charger.
Connect charging cord (USB-C) to wall
adapter (not included). The charging process
can take up to 24 hours to complete. Both
units need to be charged before installation.
Technical Data
LED Units:
Pre-programmed to blue lights but can be altered.
Please see ACO SplashLight Programming
Instructions or visit www.acobd.com/splashlight.
Be sure to exercise extreme caution when
!
handling electrical devices around water.
Note
Under normal conditions of use, a fully charged
module should last approximately three to six
months before needing to be charged again.
For optimum performance, always keep the
SplashLights fully charged to preserve lifespan.
Installing ACO SplashLight
1.
2.
www.acobd.com/splashlight
Use a lifting key to remove the grate from
the shower channel.
Remove the existing Bumper Pins from the
sides of the grate.
Premium